Rayjet 360° Sprayer with Capillary 1 Meter

Rayjet 360° Sprayer ensures an even water supply for your plants. The set consists of a capillary hose and a Rayjet sprayer and a Rayjet sprayer, which are perfectly matched to each other.

The capillary hose or drip hose is 1 metre long and has an inner diameter of 4mm. This is suitable It is suitable for connection to a PE pipe/PE hose and a sprayer or for watering with a high-pressure pump. At one end, the drip hose has an attachment head that fits perfectly on the Rayjet 360° sprayer.

The Rayjet sprayer with a 360° radius spray mist supplies your plants evenly and has a shaft length of approx. 16.5 cm. In order to be able to use the sprayer, you will need, among other things, the capillary hose with attachment head, which is specifically suitable for the Rayjet. suitable for the Rayjet. The Rayjet sprayer has a flow rate of 12 litres/hour at a min. pump capacity of 1 bar, so make sure that your pump has at least one bar. Very suitable to water e.g. soil evenly.

Installation example with pump:
1. Attach a piece of fabric hose to the water/submersible pump and fix it with a hose clamp. Install a stopcock at the other end and also fix it with a hose clamp. The stopcock provides the desired water flow or water regulation. Finally, place the pump Finally, place the pump in a water tank, making sure that there is enough hose for the watering height.

2. Optionally, an irrigation filter can be attached directly to the stopcock. The filter prevents the penetration of dirt particles and thus the clogging of the capillaries and sprayers. A PE screw connection is required to connect the stopcock to the irrigation filter. a PE screw connection is required. A non-return valve is recommended to prevent backflow into the tank, This ensures even watering. The irrigation filter is then followed by the The watering filter is then followed by the non-return valve and then a PE coupling for connection to the PE hose. It is advisable to use Teflon tape for all threaded fittings beforehand to seal them.

The whole thing is of course optional as mentioned above and the connection can also be made without a filter.

3. Now the PE hose can be prepared. To do this, a PE end plug must first be inserted at one end and the other end must be sealed with the PE coupling. the other end with the PE coupling, so that the PE hose is installed with the irrigation filter and the remaining and the rest of the irrigation parts.

A hole punch is then used to punch the desired number of holes and insert the capillary hoses. The holes in the PE pipe contract slightly after punching, thus ensuring the tightness of the hose. The distance between the holes and their number is not predetermined and depends on the number/size of the pots and how much space is available. of the pots and how much space is available.

The other end of the capillary is then connected to a sprayer, which can then be inserted into the intended watering point. watering spot.

4. Clip the submersible pump to a timer, set desired times and place in a water container. Before the Before installing the timer, check the water flow, which is regulated by means of a stopcock. It is best to do a test run so that you can see whether everything is working properly.Your irrigation system is ready!

Tip:
If a capillary gets clogged, which happens rather rarely, compressed air would help to get the hose free again. free again. Ata Clean can also be used as a preventive measure to keep the irrigation system clean.